EMUGE Blog

Three Reasons to Give Thread Milling a Chance

Jan 28, 2022 5:16:51 PM / by Marlon Blandon posted in Tool Holders, thread milling, Multi Thread Mill

0 Comments

Although EMUGE is known for its high-quality line of tapping products, there are times when thread milling is a better choice. In this post, we’ll explore a few of the key differences between the two, and when to use one over the other.

Read More

Becoming an FPC Believer

Mar 3, 2021 1:28:59 PM / by Dan Doiron posted in Tool Holders

2 Comments

Perhaps you’re on the fence over shrink fit vs. hydraulic toolholders. Or maybe your shop still uses Weldon side-lock holders and wonders why tool life is less than spectacular, or struggles with pull-out no matter how hard you tighten that collet chuck. You’re not alone. Many shops are using the same toolholder technology they started out with decades ago and are reluctant to invest in something new, or are confused over which direction they should go.

Read More